ISO INTERNATIONAL STANDARD 11095 First edition 1996-02-01 Linear calibration using reference materials Etalonnage linéaire utilisant des matériaux de reéférence ISO Reference number ISO 11095:1996(E) atagazanStandardizatio No reproduction or networking permited without license from IHS Not for Resale ISO11095:1996(E) Contents Page 1 Scope 2 Normativereferences 3 Definitions 4 General principles 2 5 Basic method 2 6 The steps of the basic method 4 7 Control method 10 8 Twoalternativestothebasicmethod 13 9 Example 16 Annexes A List of symbols and abbreviations 25 B Basic method when the number of replicates is not constant 27 Bibliography 29 ISO1996 All rights reserved. Untess otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56.CH-1211Geneve 20·Switzerland Printed in Switzerland Copyrig No reproduction or networking permited withoutlicense from IHs Not for Resale ISO ISO11095:1996(E Foreword IsO (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be and non-governmental, in liaison with IsO, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 11095 was prepared by Technical Committee ISO/TC 69, Applications of statistical methods, Subcommittee SC 6, Measurement methods and results. nex C is for information only. ii No reproduction or networking pemited withoutlicense from IHS Not for Resale