ISO INTERNATIONAL STANDARD 6744-1 First edition 1999-12-01 Binders for paints and varnishes Alkyd resins : Part 1: General methods of test Liants pour peintures et vernis - Résines alkydes - Partie 1: Méthodes générales d'essai Reference number ISO 6744-1:1999(E) ISO @ ISO 1999 ISO6744-1:1999(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii @IsO1999-All rightsreserved ISO 6744-1:1999(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard_ISO 6744-1 was prepared by Technical Committee ISO/TC 35, Paints and varnishes Subcommittee SC 10, Test methods for binders for paints and varnishes. Together with the other parts (see below), this part of ISO 6744 cancels and replaces ISO 6744:1984, which has beentechnicallyrevised —Part 1:General methods of test Part 2: Determination of phthalic anhydride content 一 —Part 3: Determination of unsaponifiable matter content -Part4:Determinationoffattyacidcontent @ ISO 1999 - All rights reserved ili