ISO INTERNATIONAL STANDARD 10487-1 First edition 1992-11-15 Passenger car radio connections Part 1: Dimensions and general requirements Connexionspourautoradios Partie 1: Dimensions et exigences générales Referencenumber ISO 10487-1:1992(E) IS0 10487-1:1992(E) Foreword ISO (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for represented on that committee. International organizations, governmental and non-governmental, in liaison with iSO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the mernber bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 10487-1 was prepared by Technical Committee ISO/TC 22, Road vehicles. ISO 10487 consists of the following parts, under the general title Passen- ger carradio connections: Part1:Dimensionsandgeneral requirements Part 2:Performance requirements ISO1992 All rights reserved. No part of this publication may be reproduced or utilized in any forrn or by any means, electronic or mechanicai, including photocopying and microfilm, without per. mission in writing from the publisher. International Organization for Standardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii INTERNATIONALSTANDARD IS010487-1:1992(E) Passenger car radio connections Part 1: Dimensions and general reguirements ISO 8820-2:—1,Road vehiclesBlade type electric 1 Scope fuse-links-Part 2:Dimensional requirements. This part of IS010487 specifies dimensions and IEc268-15:1987.Soundsystemequipment general requirements of the multi-pole connector and Part 15: Preferred matching values for the intercon- the positions of antenna sockets for radios intended nectionofsoundsystemcomponents. forfitting in passenger cars. It also specifies the contact allocation of the connec- Requirements tor. This connector is both for permanent connection of 3.1The sockets of the multi-pole connector and the the car radio to the vehicle harness and for extractable antenna sockets shall bemountedatthebackof the carradios. radio, as shown in figure 1. If a second antenna socket (defined as subantenna socket) is provided, it shall be located symmetrical tothe main antenna socket, in relation to the horizontal axis of the radio. 2 Normative references The following standards contain provisions which, 3.2The sockets of the multi-pole connector and the through reference in this text, constitute provisions antenna sockets shall be permanently mounted on ofthispartof iS010487.Atthetimeofpublication the car radio as shown in figure 1. The plug forms a the editions indicated were valid.All standards are part of the vehicle harness. subject to revision, and parties to agreements based on this part of isO 10487 are encouraged to investi- 3.3 The distance between the trim plate and the gate the possibility of applying the most recent edi- connector face shall be as agreed between vehicle tions of the standards indicated below.Members of and car radio manufacturers. IEC and ISO maintain registers of currently valid International Standards. 3.4 The socket shall have a maximum of 26 male IsO 8092-3:—1,Road vehicles — Connections for contacts grouped into three parts.A,B and C,as on-board electrical harnesses - Part 3: Multi-pole shown in figure 1. These contacts shall be tabs connectortabs- Dimensions and specific require- 2,8 × 0,5 oN with neither shoulder nor hole, in ac- ments. cordance withISO 8092-3. 1) To be published. 1